SSV Embedded Modules - DIL/NetPC

The DIL/NetPC range of embedded modules provides a simple way of adding functionality to an embedded system. They are very compact 32-bit low power embedded modules with a built-in operating system and lots of features. Processor types include Arm9, Xscale, Coldfire and AMD 586. A range of starter or evaluation kits are available for fast track development. These starter kits include a module, an evaluation board and full software package.

Module overview	Starter Kit Overview
Module Overview	Starter Kit Overview

Main Features of all embedded modules

32-bit Low Power CISC or RISC CPU with up to 400 MHz	Select by Processor Type
8, 16, 32 or 64 MByte (S)DRAM Memory
2, 4 or 16 MByte FLASH Memory with Boot Block	Select by Memory Size
10 Mbps and/or 100 Mbps Ethernet Interface	Select by Ethernet Ports
40-pin and 64-pin JEDEC DIL, 128-pin QIL, or 169-pin PGA Connectors with 2.54mm Centers
Size 5523 mm (DIL-40), 8228mm (DIL-64), 8233mm/36mm (QIL-128) or 4545mm (PGA-169)	Select by Package Type

Optional Features on some modules

Modules with USB Device and Hosts	Select by USB
Modules with CAN Interfaces	Select by CAN

Common Features of all modules

One or two serial Ports with TTL Levels, 16550 compatible
18- or 20-Bit General Purpose Parallel I/O (PIO)
Software/Hardware SPI and I2C Support
Extension Bus with Interrupts and Chip Selects
Programmable Watchdog Timer
JTAG IEEE 1149.1 Boundary Scan Test Interface
In-System Programmable over JTAG, serial and Ethernet Interface
3.3 Volt Low Power Design
Pre-installed Embedded Linux with full-featured TCP/IP and FTP/HTTP/Telnet Servers

A range of embedded modules or single board computers sbc from SSV, using Arm, Coldfire and AMD 586 processors, in DIL packages. Modules are loaded with embedded Linux or uClinux. Embedded modules include CAN, Ethernet, Bluetooth, USB and other interfaces plus embedded web servers and embedded FTP.