Atmel AVR STAVER Module - DIP

STAVER Module

An easy to use microcontroller module based on an Atmel ATmega32 in a small DIP24 package with the same pin out as the Parallax Basic Stamp, NetMedia BasicX(TM) and the BasicMicro Atom. However this DIP module doesn't run an interpreter but uses compiled code so is faster and more efficient. Code can be written in a C compiler, BASIC compiler or it can be programmed directly in Assembler. Downloading code is done via the built in RS232 interface, so there is no need for an external programmer.

---

Features of the StAVeR-24M32

• 30Kbytes of Flash code memory
• 2Kbyte of Flash BOOT code (for downloading code)
• 1Kbytes EEPROM
• 2Kbyte SRAM
• One external interrupt sources
• Two 8-bit Timers
• One 16-bit Timer
• 8 10-bit ADC channels
• I2C hardware interface
• Master SPI interface via 6pin connector according to original Atmel ISP programmer but with a smaller header
• Programmed via RS232, no need for external programmer
• ESD protected RS232 up to 115.2Kbaud
• On board Green, Yellow and Red LED.

---

Pin out of Staver Module

---

This module has all the benefits of units such as the BASIC Stamp but the code is compiled rather than interpreted. This means that you can write your code in your chosen language (Assembler, BASIC, C or PASCAL)but it runs at full speed on the Staver Module. Not only does your code run thousands of times faster, but it also takes up far less space giving you much greater flexibility.

30KB user code space (with no page boundaries to worry about)

Faster than 1 million instructions per second

2KB SRAM for data storage

Programmable via of serial cable with software included, or you can use an In System Programmer

Capable of handling integers up to 4,294,297,295 (32bit) plus fast floating point maths routines

Kit includes software for programming