Wellon socket position

Home Forums Kanda Forums Technical Support Forums Wellon socket position

This topic is: not resolved

This topic contains 1 reply, has 2 voices, and was last updated by  Kanda Admin 5 years, 3 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #489

    georgeC
    Participant
    Post count: 1

    I get Wellon VP-596 programmer and 32-pin TSOP socket. How I place socket in programmer?

    #494

    Kanda Admin
    Keymaster
    Post count: 324

    Wellon sockets are always placed in the bottom of the ZIF socket, away from the handle end. The socket also has the writing towards the handle end, see picture (the jagged white blob is not usually there).

    The device is placed in the socket so pin 1 of the device is as close as possible to the white dot on the socket. In the attached picture, pin 1 of the device would be top right of socket, that is closest to white dot.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Microcontrollers, training, electronics and coding